This Princess Poppy Costume DIY, inspired by the movie Trolls is an easy sew!
Some quick seams and some Velcro and you have a Princess Poppy costume. In the example I used felt, but fleece will also work for this pattern – but felt is a lot less expensive and great for costumes.
For this Costume DIY you will need:
1 yard of felt or fleece in blue
1/4 yard White felt or fleece
3 inches of sew on Velcro
Green Spray Paint (optional)
masking tape (optional)
Princess Poppy Costume DIY Video Written Tutorial Below:
Princess Poppy Costume DIY:
Step 1 -Assemble the free pattern and cut out the pieces
You can find instructions on how to assemble the pattern here. Please note that there is something a little funky about this pattern. Since the front and the back are not symmetrical I have made two different colored lines on the top. One is for the front and other is for the back. I’ve done it this way so you don’t have to assemble two large pattern pieces and it saves paper. You need to pay close attention to the instructions or you will cut it out wrong.
When you cut out the pattern make it so you cut the most outside line on the pattern. Place the pattern on doubled fabric. Cut out through both layer up to the tops of the armcye ( arm holes) then stop. Separate the two pieces, and repin to just one piece of cloth.
Fold the little triangle down so the red line in one continuous line. The cut out the top along the red line. Set back piece of dress aside
Now cut the pattern along the purple line as shown and unfold the triangle you folded down. Take the remaining piece of the dress and pin the pattern to it.
Cut out the front.
Set the front aside
Cut one of the front flap.
Cut a strip of whit fabric that is about 2 inches wide and 8 – 10 inches long.
Step 2 – Sew the Princess Poppy Costume DIY Dress Together
Using a .25 inch seam allowance, sew the sides ( bottom to bottom of armcye) and at the strap on the shoulder. Then Sew on the Front crossover piece, using a .25 inch seam allowance.
Once you have sewn all of that, turn it right side out.
Step 3 – add the Velcro
Lay the cross over piece on the front of the dress and place where you would like it to attach. Take your velcro and using a making pen mark where the Velcro will be on the dress front and the cross over piece. Sew on the Velcro.
Step 4 (optional) – make the ombre at the bottom of the dress
You might have notices that Poppy’s dress has a subtle green ombre at the bottom ( this is a subtle clue that she and branch belong together…sorry film student moment). To achieve this look just get some cheap spray paint and tape the bottom of the dress. Go across the dress a couple times, then lift up the next layer of paint spray a couple of times, lift up the next layer. I strongly recommend that if you are going to do it, do it now. Before you add other detail.
Step 5 – Add the white decor
Layout where you want the white pattern to go on the bottom of the dress.
Using a hot glue gun you can glue down the decor.
Or using a sewing machine and a zig zag stitch you can applique it on.
Final touch: take the white strip you cut and fold it half, then twist it. Snip a little hole in the cross over piece and insert one end int, snip a second hole on the other side and insert the ends in.
Glue in place with a hot glue gun and trim ends if necessary ( this should cover the Velcro rectangle so it’s not seen.) You’re finished with the Princess Poppy costume DIY!
Download the free pattern, tutorial below!